I've received a few questions about the Christmas wreaths I made in my last post. Here's a few instructions, hope they help.
If you would like to make some of these weaths, I have kits available. They have the supplies to make 3 wreaths (3 rings, 3 jingle bells - one of each size, ribbon, bows and baker's twine). All you will need is the hot glue gun or other adhesive to attach the bows. The kits are $16.00, plus postage (Australia only). Send me a message or email if you would like a kit, and let me know what ribbon colours you would like, and I'll put the kit together for you.
Here's the instructions:
Start with knotting the ribbon around the ring like below. Halve the length of ribbon and place under the ring, bring the left side over the ring, the right side over the left ribbon and under the ring and through.
Tie each knot firmly. Then keep knotting around the ring as above. If you know macrame knots this one is the half square knot which gives the twisted effect, BUT you must keep the knots exactly the same all the way round.
Continue until you meet up with the starting point....
Thread one of the ribbon ends through the bell....
This is the step you can choose which way the bell hangs, down under the wreath....
...or in the middle of the wreath....
Loop the string or bakers twine around the ring, this is the hanging part of the wreath...
Tie a double knot to hold the bell in place....
Trim the excess lengths of ribbon from the knot....
Add the bows front and back. I used a hot glue gun to attach the bows. Adding the bows is not only decorative, but it helps hide the knotted ends of the wreath and holds this all in place...
Hope you enjoy making these :) Ribbons and bows are from Ribbons Galore (www.ribbonsgalore.com.au).
Thanks for visiting.
Cheers
Fiona x
